Reverse direction of cutter for clean cutting on EPS and PU foam and more symmetrical cutting on all boards
Elimination of the nose and tail wings due to a more efficient spatial rearrangement of the machine
Auto-Oiling - no more getting dusty in the morning before you cut any boards while the machine stays fully lubricated
Lifted Machine - new machine is higher off the ground. No more bending over when loading and unloading.
Better stringer alignment - new laser setup with cutting file improvements, provides better symmetry and a much better workaround with blanks with less than straight stringers
Simple and efficient machine design - anywhere from the cutting motion to the placement of belts, the simple design
of the machine makes it easy to figure out its operation and service
All steel construction - greater stability and less vibration
No blank distortion due to unique holding mechanism
Fast blank loading
Handles max 12' blanks on standard machine (13' blanks on extended machine)
Handles max 33" width blank sizes
Easily adjustable for different blank sizes
Diamond tip high tensile tungsten steel cutter
3.5 - 4 surfboards per hour with standard finish
Industrial quality controller with custom machine interface
AC brush less servo motors
Board positioning within blank on screen (minimal cutting depth in deck)
All cutting parameters within design program on screen
Can cut flat, V, convex, concave, winger, stinger and so on
Flush stringer cut
Board finish over 95%
Rail can be cut to 98% (slight botttom edge is left)